If the screen is flashing, make sure the monitor is sitting on a flat surface. The orientation can also be changed:
Click on Home
General tab
Set orientation to horizontal or vertical.
If this does not work do the following to calibrate:
Click on Home
About
In the black area below canine/feline and above the ECG box, double click in that area. This will bring up a keypad, enter 5967.
At the bottom of the screen click on Module Config… then select Calibration. Make sure the monitor is on a flat surface and is vertical.
Under Acceleromater click on calibrate. This will bring up a screen with a picture of how the monitor should sit, click calibrate. System message will pop up saying Calibrating…please wait.
Click close then restart the monitor.
Last Modified: 04/22/2019